Pioneer Tools for CCKW Rack
According to the pics I received, my shop van has a pioneer tool rack located on the drivers side near the hood. What tools go there and what size? Any suggestions as to who sells them?
Pioneer Tools for CCKW Rack
- Lucky Forward
- First Lieutenant
- Posts: 63
- Joined: Sat Jan 05, 2008 10:42 pm
- Location: Hockley Texas
- Contact:
Pioneer Tools for CCKW Rack
WC 57 Dodge Command Car "Patton command car"
CCKW 1942 Shop Van "Patton command van"
GPW Ford Script 1943 Jeep
Ben Hur Trailer
1/4 ton Batam trailer
M-20 Armored car "Patton's M-20"
1942 CCKW
1942 International Harvester 1 1/2 ton
MVPA #9986
http://www.pattonthirdarmy.com
CCKW 1942 Shop Van "Patton command van"
GPW Ford Script 1943 Jeep
Ben Hur Trailer
1/4 ton Batam trailer
M-20 Armored car "Patton's M-20"
1942 CCKW
1942 International Harvester 1 1/2 ton
MVPA #9986
http://www.pattonthirdarmy.com
- Karoshi
- Lieutenant Colonel
- Posts: 563
- Joined: Thu Jun 08, 2006 1:10 am
- Location: UK
Lucky, the universal Pioneer rack carried the same tools set as the CCKW running board set up, and takes the standard Jeep fit out for Axe and Shovel, so repros should be available. The same rack was used across a wide spread of vehicles so the pick-mattock is no doubt available through a range of agents.
Axe, chopping, single bit 5lbs. Stock No 41-A1277
Mattock, pick M1, with handle. Stock No 41-M-720
Shovel, D handle. round point. Stock No 41-S-3170
No picture at this time, but I'll shoot a couple for you when I re-equip in a couple of weeks time.
Axe, chopping, single bit 5lbs. Stock No 41-A1277
Mattock, pick M1, with handle. Stock No 41-M-720
Shovel, D handle. round point. Stock No 41-S-3170
No picture at this time, but I'll shoot a couple for you when I re-equip in a couple of weeks time.
-
- First Lieutenant
- Posts: 107
- Joined: Mon Jan 28, 2008 4:10 pm
- Location: U K South coast
Re: Pioneer Tools for CCKW Rack
Was there no requirement for a sledge hammer ? I know I have not seen one on the running boards or in the racks, just wondered.
Don't say can't as anything is possible with time and effort.
1941 CCKW352B1
GP Medium tent
105 M2-A1 Howitzer
1941 CCKW352B1
GP Medium tent
105 M2-A1 Howitzer
Re: Pioneer Tools for CCKW Rack
I believe the sledge hammer as only part of the pioneer tools on Armoured tracked vehicles as in Tanks and High speed artillery tractors and perhaps Wreckers .
-
- First Lieutenant
- Posts: 107
- Joined: Mon Jan 28, 2008 4:10 pm
- Location: U K South coast
Re: Pioneer Tools for CCKW Rack
Ahh so did they have a special rack for it or did it go on the standard Pioneer rack ?
Don't say can't as anything is possible with time and effort.
1941 CCKW352B1
GP Medium tent
105 M2-A1 Howitzer
1941 CCKW352B1
GP Medium tent
105 M2-A1 Howitzer
Re: Pioneer Tools for CCKW Rack
A very good question , perhaps one of the others will know all the facts and can correct my information shortly.
- Cat Man
- Major
- Posts: 420
- Joined: Thu Jul 20, 2006 9:55 pm
- Location: Green Bay WI
Re: Pioneer Tools for CCKW Rack
The 10 Pound Blacksmith Sledge Part # 41-S-3726 was not part of the authorized CCKW pioneer tool set.
You have to get to a much larger specialist vehicle before the sledge hammer is authorized. The CCKW and even the 4 Ton Diamond T wrecker did not carry one. However the 10 Ton M1A1 Ward LaFrace/Kenworth wrecker has a bracket on the righthand running board for the sledge hammer.
The M26 Pacific also carried one or two of the sledge hammers. They were located outsidethe armored cab in special brackets above the left front wheel.
Sledge hammers are also part of the combat engineer pioneer squad and platoon tool kits.
Cat Man
You have to get to a much larger specialist vehicle before the sledge hammer is authorized. The CCKW and even the 4 Ton Diamond T wrecker did not carry one. However the 10 Ton M1A1 Ward LaFrace/Kenworth wrecker has a bracket on the righthand running board for the sledge hammer.
The M26 Pacific also carried one or two of the sledge hammers. They were located outsidethe armored cab in special brackets above the left front wheel.
Sledge hammers are also part of the combat engineer pioneer squad and platoon tool kits.
Cat Man
40 Years An Engine Guy
30 Years A Caterpillar Guy
Still Learning Every Day
30 Years A Caterpillar Guy
Still Learning Every Day