Page 1 of 1
HydroVac Series 3
Posted: Wed May 03, 2006 8:03 am
by Karoshi
Does anybody have or know of a supplier of Series 3 Hydrovac overhaul kits. I'm looking for one.
Thanks
Posted: Fri Jan 05, 2007 10:35 pm
by Hardbird
Does anyone here have any leads on these kits?
The Series II kits seem to be available NOS, but not the later Series III.
Thanks,
Ron
Posted: Sat Jan 06, 2007 5:03 am
by Karoshi
Ron, I had no luck, I was able to find Type 2, but no Type 3's.
I rebuilt my own in the end, using a Type 3 kit.
Re:
Posted: Sat Jan 06, 2007 11:27 am
by Hardbird
Karoshi wrote:Ron, I had no luck, I was able to find Type 2, but no Type 3's.
I rebuilt my own in the end, using a Type 3 kit.
You said that you used a Type 3 kit to rebuild yours? Where did you get that at? This is what I am looking for, a Type 3 kit, not a whole unit.
Thanks,
Ron
Sorry
Posted: Sat Jan 06, 2007 1:34 pm
by Karoshi
Sorry Hardbird, finger trouble there.
I used a Type 2 kit. I seem to remember the rubber seals were 3/4" and 1.1/4". with only two seals in the whole unit. It was a pretty straight forward overhaul and no more difficult to do than a master cylinder rebuild.
Sorry for misleading you.
My parts were sourced in the UK from REX WARD.
http://www.milweb.net/go/rexward/