HydroVac Series 3

Karoshi · Post by **Karoshi** » Wed May 03, 2006 8:03 am

Does anybody have or know of a supplier of Series 3 Hydrovac overhaul kits. I'm looking for one.

Thanks

Hardbird · Post by **Hardbird** » Fri Jan 05, 2007 10:35 pm

Does anyone here have any leads on these kits?

The Series II kits seem to be available NOS, but not the later Series III.

Thanks,
Ron

Karoshi · Post by **Karoshi** » Sat Jan 06, 2007 5:03 am

Ron, I had no luck, I was able to find Type 2, but no Type 3's.

I rebuilt my own in the end, using a Type 3 kit.

Hardbird · Post by **Hardbird** » Sat Jan 06, 2007 11:27 am

Karoshi wrote:Ron, I had no luck, I was able to find Type 2, but no Type 3's.

I rebuilt my own in the end, using a Type 3 kit.

You said that you used a Type 3 kit to rebuild yours? Where did you get that at? This is what I am looking for, a Type 3 kit, not a whole unit.

Thanks,
Ron

Karoshi · Post by **Karoshi** » Sat Jan 06, 2007 1:34 pm

Sorry Hardbird, finger trouble there.

I used a Type 2 kit. I seem to remember the rubber seals were 3/4" and 1.1/4". with only two seals in the whole unit. It was a pretty straight forward overhaul and no more difficult to do than a master cylinder rebuild.

Sorry for misleading you.

My parts were sourced in the UK from REX WARD.

http://www.milweb.net/go/rexward/

The GMC CCKW

HydroVac Series 3

HydroVac Series 3

Re:

Sorry