Dataplates on my M-10

Bill_Wolf · Post by **Bill_Wolf** » Tue Jul 12, 2005 1:25 am

Rob,

I believe you said you wanted to see M-10 Data plates.

These are not for sale...

I have a different load plate on my other M-10 which I will get off and shoot pictures of.

The load plates appear to be made of lead.

Bill

Thundercat97 · Post by **Thundercat97** » Tue Jul 12, 2005 7:49 am

Yep, I did.... thanks Bill, those are the two I have. Do you have a rear pintle... can you take some good photos so I know what I am hunting for?

Mine is also a Schelm Brothers - 1944

Thanks,
Rob

Tim Sutter · Post by **Tim Sutter** » Sat Nov 05, 2005 4:44 am

Hi does any one have the Black out light switching box, or the switch, and I am also in need of the cast iron ring that you pull to get the lunette to swivel. Can any one help? Thanks Tim

Bill_Wolf · Post by **Bill_Wolf** » Sat Nov 05, 2005 11:48 am

Tim,

This might help

http://www.cckw.org/m10_technical.htm

Bill

Tim Sutter · Post by **Tim Sutter** » Sat Nov 05, 2005 12:44 pm

Thanks again Bill, those are the best things as far as research materials is concerned that I could hope for. I may be able to guess what size they are from the things around them and on my halftrack most things were close to some hole inch measurement (5" 5 1/2" 6" 6 1/2" etc.). But am I dreaming to hope someone may have one of these for sale? Thanks Tim

Bill_Wolf · Post by **Bill_Wolf** » Sat Nov 05, 2005 1:34 pm

Tim....

The dimensions of the box are on the webpage

http://www.cckw.org/m10_technical.htm

The large hole is for the standard trailer plug female fitting used in WWII. The small hole is the diameter of the switch.

I will see if I can get the latch handle off my M-10 trailer #2. If I can you can use it as a template....

Bill

Tim Sutter · Post by **Tim Sutter** » Sun Nov 06, 2005 1:09 am

Were the yellow dimensions there all along? I can't believe I missed that, I must be blind.

Thanks again Bill If I could borrow the cast ring lunette release thing I would be very grateful. I would make a silicon mold and pour a plastic one then I have to increase it dimensionally 5% so when the molten metal cools the new one will be the same size. Thanks Tim

Thundercat97 · Post by **Thundercat97** » Mon Nov 07, 2005 10:17 am

Nice job Bill......

what type of tires do you have on your M10 Trailer?

Rob

Bill_Wolf · Post by **Bill_Wolf** » Mon Nov 07, 2005 10:28 am

The one that I restored first came with Military highway tires. I have left those on the trailer...for now.

The other 2 had bastard replacement tires on them.

I have a set of 900/20 NDT's on Combat rims that are awaiting painting for trailer #2.

I know both were used. My opinion is that the NDT's look more "Combatish"

Bill

The GMC CCKW

Dataplates on my M-10

Dataplates on my M-10

M-10 ammo trailer Black out light switch box

Thanks again Bill

Wow I must be blind