Banjo axle rear brake hose

[Nick Bombini]

Does anyone have the part number for the rear brake hoses on a banjo axle CCKW?

Thanks,

Nick

[mudflap]

If its the type of installation where there is one hose for each wheel cylinder, the GM PN is: 2076248

This PN crosses over to a number of aftermarket hoses, such as Dorman H4000 and NAPA 4000.

I recently purchased the NAPA hoses for my truck. They are made in China, but appear to be well made.


Best Regards...

[Nick Bombini]

Excellent! I've searched for quite awhile on the net and couldn't find any numbers. I just pulled one off the truck so I'll compare it just to make sure it's the same.

Thanks for the help!

--Nick

[mudflap]

No problemo.. I would be curious to know what you measure for the length of your current hoses.

My original ones were about 1.5" longer than the replacements. However, everything I found suggested that the replacements were the correct length.

So, I can't help but think that maybe the originals (which had a DOT date from like the early '80s) were perhaps not the correct PN....

Best Regards...

[Nick Bombini]

I had the local Napa order a brake hose so I can check it out. It was an exact match to the one I took off the truck. I've got more on the way now.

The one I took off was 19 1/2" long. I had to chuckle due to the fact that my WWII American truck that is a Norwegian return has brake hoses that say "Made in Japan".

Once again, I appreciate your help. There was definitely a lack of info regarding the hoses.

--Nick